Joysticki przemysłowe 40JEK na bazie switchy (SW) - Digital Code (IP40, IP54)

Thank you for your inquiry but this joystick was discontinued and so unfortunately we cannot provide you with the same one. The replacement is H40JEK series. Here is its catalog page. (with Hall IC, Vin=5V open drain output) https://sakae-tsushin.co.jp/eng_page/pdf/joy/e_H40JE.pdf  o attached pdf H40JEK can have 4-bit grey code as the same as the requested 40JEK-YQ-07R2G. But H40JEK accepts only DC 5V of power, while 40JEK can accept the power within DC 12V 1mA. So the acceptable voltage of H40JEK is lower than 40JEK. Could you check if your customer can accept open drain output, and if they can input DC 5V on the joystick? Here is the quotation for SH40JEK. SH40JEK-YQ-24G0R2G-XXXXX(to be replaced to a 5-digit number) * 2 axes, 4 bit grey code * Lead time for 1-2 pcs.: About 8-12 weeks after receipt of your firm order & payment * Validity of this quotation: 1  months from today H40JEK makes output from Hall IC, while 40JEK is digital output from code switches. As shown in the attached sketch, you need to connect each bit to 5V with pull-up resistor. Lastly please let us inform something about the output. If the customer has used 40JEK connecting power to COM, its output pattern is reversal to H40JEK. In order to get the same output pattern with H40JEK, they need to add an inverter to the circuit. Please note - if it is NCNR (non-cancelable non-returnable product) - it is on special order from producer - there is no possiblity to cancel or resign the order on any stage of order.

rEPLACEMENT FOR 40JEK-YQ-07R2G Thank you for your inquiry but this joystick was discontinued and so unfortunately we cannot provide you with the same one. The replacement is H40JEK series. Here is its catalog page. (with Hall IC, Vin=5V open drain output) https://sakae-tsushin.co.jp/eng_page/pdf/joy/e_H40JE.pdf  o attached pdf H40JEK can have 4-bit grey code as the same as the requested 40JEK-YQ-07R2G. But H40JEK accepts only DC 5V of power, while 40JEK can accept the power within DC 12V 1mA. So the acceptable voltage of H40JEK is lower than 40JEK. Could you check if your customer can accept open drain output, and if they can input DC 5V on the joystick? Here is the quotation for SH40JEK. SH40JEK-YQ-24G0R2G-XXXXX(to be replaced to a 5-digit number) * 2 axes, 4 bit grey code * Lead time for 1-2 pcs.: About 8-12 weeks after receipt of your firm order & payment * Validity of this quotation: 1  months from today H40JEK makes output from Hall IC, while 40JEK is digital output from code switches. As shown in the attached sketch, you need to connect each bit to 5V with pull-up resistor. Lastly please let us inform something about the output. If the customer has used 40JEK connecting power to COM, its output pattern is reversal to H40JEK. In order to get the same output pattern with H40JEK, they need to add an inverter to the circuit. Please note - if it is NCNR (non-cancelable non-returnable product) - it is on special order from producer - there is no possiblity to cancel or resign the order on any stage of order.